4.5 out of 5
Customer Reviews
Items 1 - 1 of 1 reviews
1
By
Sabrina Miller
Date: March 20, 2018
The flux works well, but the push stick for the plunger won't stay in the tube. Normally when you stop pushing down on the plunger you want to pull back a little to stop the flow...since the stick won't stay in place it tends to make a mess as the flow continues until you can get the snap on cap over the end. Since the stick won't stay in...it was a bit trick using it until I figured out how to just push some out on a scrap of plastic and then use a tooth pick to apply to the PCB.
Rating: 
[3 of 5 Stars!]
[3 of 5 Stars!]
Items 1 - 1 of 1 reviews
1