0 reviews
Be the first to review this item!
CRL 2604 1/4" Prismatic Glass Drill, Price/Each
Brand CR Laurence
Shop more from BCR
* Click "Add to Cart" to calculate shipping and delivery time.
Product Description
Price is for Each.
Manufacturer Part Number: 2604
Our Best Carbide Drill
Precision Ground on Three Sides
Available Sizes from 1/8" to 1/2" (3.2 to 12.7 mm)
This CRL Prismatic Glass Drill is the standard of quality for glass drilling throughout the flat glass industry. The tungsten carbide tips mean you can produce hundreds of high quality holes without needing to re-sharpen the drill. The extra long tip assures long lasting, precision drilling.
Prismatic Drills should only be used in glass drilling machines such as the CRL2, SDM4, and 41, or in a securely held electric drill. We do not recommend you use them with hand brace drills. Be sure to keep the drill cool using CRL Cat. No. PGT1 Pure Gum Turpentine or another coolant, such as CRL DTC80 during drilling.NOTE: Always wear the proper safety gear, including gloves and eye protection, when drilling glass. Work should be performed on a flat, horizontal surface. A Ground Fault Circuit Interrupter, such as CRL Cat. No. GF1, must be used when using any type of electric tool in conjunction with water or coolant. Failure to follow any of these precautions can result in operator injury.
Product Warning:
These drills should be run at 400-600 RPM to achieve maximum drilling performance. The tip of the CRL Prismatic Drill is not ground to a sharp point. There is a slight angle at the tip to allow the drill to first scratch the glass and begin the drilling of the hole.
- Drill Bit Size (Inches): 1/4
- Material: Carbide
- Shank Diameter (Inches): 1/4
- Shank Type: Reduced Round
- Speed (RPM): 500-600
- Works On: CRL2 And SDM4
Our Best Carbide Drill
Precision Ground on Three Sides
Available Sizes from 1/8" to 1/2" (3.2 to 12.7 mm)
This CRL Prismatic Glass Drill is the standard of quality for glass drilling throughout the flat glass industry. The tungsten carbide tips mean you can produce hundreds of high quality holes without needing to re-sharpen the drill. The extra long tip assures long lasting, precision drilling.
Prismatic Drills should only be used in glass drilling machines such as the CRL2, SDM4, and 41, or in a securely held electric drill. We do not recommend you use them with hand brace drills. Be sure to keep the drill cool using CRL Cat. No. PGT1 Pure Gum Turpentine or another coolant, such as CRL DTC80 during drilling.NOTE: Always wear the proper safety gear, including gloves and eye protection, when drilling glass. Work should be performed on a flat, horizontal surface. A Ground Fault Circuit Interrupter, such as CRL Cat. No. GF1, must be used when using any type of electric tool in conjunction with water or coolant. Failure to follow any of these precautions can result in operator injury.
Product Warning:
These drills should be run at 400-600 RPM to achieve maximum drilling performance. The tip of the CRL Prismatic Drill is not ground to a sharp point. There is a slight angle at the tip to allow the drill to first scratch the glass and begin the drilling of the hole.
Attention CA Residents: Prop 65 Warning
WARNING:
This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.p65warnings.ca.gov.
Return Policy
Return could only be applied within 7 days after delivery.
Need more information?
Our staff are available to answer any questions you may have about this item
Our staff are available to answer any questions you may have about this item
Look Similar Items By Category