Installation was a little annoying due to two air bubbles under the magnet sheet, but that was my fault. I ended up poking tiny holes to let the air out so it would be flat. On my ender 3, the print surface is about 6 mm larger than the aluminum bed, so it hangs off 3 mm on each side. Not a problem but something to be aware of. With a small firmware change, you gain about a centimeter of printable area compared to stock with clips. (Mine is now 235x230x245) ABS adhesion is very strong, fantastic for preventing ABS peeling off the bed.
Rating:
[5 of 5 Stars!]