5 out of 5
Customer Reviews
By
Adyson88
Date: May 25, 2022
This bed came stock with my Ender 3 but I had to upgrade fairly quickly. These are great stock beds but you will want to upgrade to a glass or PEI sheet once you get up and running due to their overall quality. Nothing “wrong” with these beds but you will probably replace them more than you want to and might take away some of the cost effectiveness. If you are a hobbyist or just printing every once in a while these will do the job, but you will probably upgrade sooner than later
Rating: 
[4 of 5 Stars!]
[4 of 5 Stars!]
By
KDubya
Date: May 16, 2022
The polarity of the magnetic bed is 90 degrees from the original on my ender 3. when using with the magnet already applied to the bed, this new sheet I had to rotate 90 degrees to get a strong hold. Because of this, I had to trim off that extra tab that normally is towards the front of the printer.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
Kayleigh
Date: May 11, 2022
The magnet doesn't line up properly but we worked around it
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
sinister1273
Date: April 15, 2022
product came perfectly , all in working order
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
LAKdad
Date: April 09, 2022
This replacement mat does stick as well as the original.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
Anthony
Date: March 10, 2022
Magnets are off 90 degrees. It would only hard lock 90 degrees the wrong way.I cut off the tab and it works just looks silly.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
danny chandler
Date: March 08, 2022
Don't waste your money on anything else. The magnet strength on this is way stronger than most generics. It's also roughly the same price. You do still have to use clips but the difference in quality between this and the other generics is uncanny.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
charlie
Date: March 01, 2022
The printer I have came with this same removable print surface. The problem is it sticks to the base with magnetic adhesion, only the magnetic poles are not the same. The replacement pad doesn't stick well with the magnetic base on the printer unless you turn it 90deg and then the handle part of the pad makes it too wide. It comes with a new base so you can replace the one you have but it would be a lot nicer if the magnetic poles were the same.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
Public Name
Date: February 23, 2022
Good adhesion and easy to get print off.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]