skip to footer block
Customer Reviews
5 out of 5
5 stars
71
4 stars
12
3 stars
0
2 stars
0
1 stars
0
Items 61 - 80 of 83 reviews
[Prev]   1  2  3  4  5  [Next] 
By D. Go
Date: July 03, 2021
Thick padded shielding with very strong adherent. Reflecting heat into room away from wall. I am happy with the heat resistance to the wall I have heater mounted on.
Rating: [5 of 5 Stars!]
By deborah s tucker
Date: June 29, 2021
Never used adhesion but placed on mail truck floor but not helpful in blocking heat
Rating: [5 of 5 Stars!]
By gcphost
Date: June 10, 2021
I must say after looking at dozens of products, reading hundreds of reviews, I settled on giving these a go as everyone says they actually keep the temp down. I'm here to chime in and agree, they certainly do! I'm building a vintage race car and without any interior bits it sure would get hot. One layer of this in the transmission tunnel has reduce the temps considerably, sadly no temp gun, but my butt dyno says its solid.I'll be ordering more for another layer and possibly try some on on the inside.It looks good too, cut it right and you get a factory style finish.1 start docked cause the adhesive could be better. My car is 50 years old and has had a self lubricating chassis for a while. I cleaned with brake parts cleaner and acetone and most of the tunnel stuck without issues. Some areas, where there was texture underbody coating, never really stuck. It would be nice to find something with more of a tar like backing, I'd also feel more comfortable with water and future issues with rust if was like that.
Rating: [5 of 5 Stars!]
By Traz
Date: March 26, 2021
The product was thin enough to not make it a tight fit when shaped and placed on the exterior of the glove box of my 2019 Can Am Ryker, along with the aluminum tape at the seams. The glove box sits above within the engine compartment so the interior would get heated after a ride. Now it is much cooler due to the insulation.
Rating: [4 of 5 Stars!]
By Daniel Anderson
Date: March 14, 2021
Product arrived quickly. Good value.
Rating: [5 of 5 Stars!]
By Albert Anaya
Date: March 04, 2021
Thx
Rating: [5 of 5 Stars!]
By Paula B.
Date: February 28, 2021
This heat shield protects my upper cabinets from my toaster oven. Getting another for over my coffeemaker.
Rating: [5 of 5 Stars!]
By wanna see it
Date: February 15, 2021
Very good and as expected
Rating: [5 of 5 Stars!]
By A. Brattoli
Date: February 07, 2021
I used this to line the inside of the cabinet hood over the oven. The material is very easy to work with and the adhesion is very good. Recommended.
Rating: [5 of 5 Stars!]
By Cathy Mason
Date: January 24, 2021
Keeps cabinets from catching on fire and looks great!
Rating: [5 of 5 Stars!]
By Linda Day
Date: January 24, 2021
I have this mounted under a cabinet that sits over my toaster oven. It works great to keep the spices and other foods in the cupboard above at room temperature, even when I'm running the oven at high temperatures for 20 minutes or so. In the past, I had to move the oven out from under the cabinet to use it.
Rating: [5 of 5 Stars!]
By Ken K
Date: January 12, 2021
I bought this to shield the bottom of the cabinet where I have a large toaster oven. There is about 10 inches of clearance but it was close enough to noticeably heat up the inside of the cabinet when I was using the oven for baking or broiling. This barrier was easy to cut and install, sticks well to the wood, and does a very effective job blocking heat transfer. Would highly recommend for this purpose.
Rating: [5 of 5 Stars!]
By BONNIE
Date: December 28, 2020
Easy to trim to fit and install. Looks good. Really didn't need as NUWAVE oven doesn't get that hot ..better safe than sorry
Rating: [5 of 5 Stars!]
By Loretta Cook
Date: December 25, 2020
I got this for the side of my new frig my stove is wright next to it. My old frig wasn't as wide and had more room between them. This product is so thin and easy to work with i am going to buy more. Very happy with it
Rating: [5 of 5 Stars!]
By Ralph
Date: October 31, 2020
Seems like a good product. Will not work for my intended use.
Rating: [4 of 5 Stars!]
By C. S.
Date: September 30, 2020
This product is awesome. We used it to line a cabinet where we place our toaster oven. It completely deflects the heat and protects the wood. I feel much safer using my oven now. Great product!
Rating: [5 of 5 Stars!]
By Gabriel
Date: September 29, 2020
The product is good however, the seller is ripping you off. You can buy a 25ft x 4 ft roll of this stuff at homedepot for $30.
Rating: [4 of 5 Stars!]
By Jeff
Date: September 19, 2020
Used it to protect side sills from a hot exhaust tip. Haven't had it on long enough to comment on how well it works, but it sticks very well, easy to apply and cut with scissors and appears to be of the same thickness as the OEM heat wrap used elsewhere on the vehicle. I wish I had bought a little bit more, but I made it work.
Rating: [5 of 5 Stars!]
By Jordan barrett
Date: September 15, 2020
The adhesive is pretty good the thickness is pretty thin but it does the job. I would back it up with some fiberglass reinforced aluminum tape and get a thicker heat shield for the entire hood
Rating: [4 of 5 Stars!]
By Cory clay
Date: September 06, 2020
just be sure you are ready to stick it when you pull the peel back. if you have to restick it. it doesn't bond very good. but other then that it works well.
Rating: [5 of 5 Stars!]
Items 61 - 80 of 83 reviews
[Prev]   1  2  3  4  5  [Next]