5 out of 5
Customer Reviews
Items 1 - 8 of 8 reviews
1
By
Steven
Date: November 20, 2023
I love using these for coil taping on guitars. Throw and turn resistance feels soooo good. Little bigger than some pots so make sure you have the room before you start soldering!
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By
wetippett
Date: October 13, 2023
I have not installed them yet but will review the performance later
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Michael
Date: August 09, 2023
Nice pot works well
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Dominic N. Puleo
Date: December 17, 2022
If in doubt get some pot
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
mike
Date: October 23, 2022
A little bulky, so not great for tight spaces but good quality and very close to the specified resistance rating.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Masterblaster
Date: July 07, 2022
I replaced a bourns 500k dpdt pot with this pot and I couldn't be happier, Bourns pot was way to noisy and super low torque, this pot seems to be better built than bourns and the noise level is significantly less, the only gripe I had was my schecter knob was very snug on this pot compared to bourns
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Alex M
Date: September 19, 2021
I installed this as a tone knob an HSS strat build in order to get some single-coil bridge tones in addition to the standard humbucker. Unfortunately, the body for my Strat is a thin-bodied Squier, so I ended up having to do some routing in the control cavity to fit the height of this pot (though this will be the case with most all push/pull pots).Aside from that, the quality is great so far and it sounds wonderful. Would recommend.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Thomas Cookson
Date: February 24, 2021
Prefect for modding my LP guitar
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
Items 1 - 8 of 8 reviews
1