5 out of 5
Customer Reviews
By
Michael M.
Date: December 08, 2021
If you crank down on they will crumple and definitely not keep out any water
Rating: 
[4 of 5 Stars!]
[4 of 5 Stars!]
By
Michael Maxwell
Date: November 15, 2021
These fit well on most truck-sized tie rod ends like the FJ-80 rod ends on my 4Runner and also my 1-ton prerunner Econoline van.
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By
doorknob
Date: September 18, 2021
Lots of ability to fit different steering ends and they will keep the dirt out and seal well and the rubber quality looks excellent
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Steve schmalz
Date: August 02, 2021
exactly what i wanted
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
.
Date: June 25, 2021
Used to replace torn boots on my '47 Ford -- worked great.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
J
Date: June 09, 2021
Perfect fit for my 99 Tahoe tie rid links. Installed in place. Too easy.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
FormosaJeremy
Date: June 06, 2021
perfect for y truck
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
scott booher
Date: May 25, 2021
These urethane boots worked well on my chevelle project replacing the dried out and torn rubber ones.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Telephone
Date: April 05, 2021
Boot on my 2001 Ford E-350 van's pitman arm tie-rod end was torn and leaking grease. This worked great to fix that problem.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
The Texan
Date: March 24, 2021
Should work
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Raz
Date: February 20, 2021
The original style boots were cracked while the tie rods were still good. Installed the replacement caps and they sealed nicely to retain the grease in the tie rods.I plan to keep some of theses on hand for replacing old and defective boots. They should for most GM tie rods.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Casey K.
Date: October 30, 2020
Good stuff
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Jeffery M.
Date: September 26, 2020
boot worked no seal at bottom. Used on Outer tie-rod ends. I Removed old outer Tie-Rod boot and wire retainer on lower side. When Installing new boots found new ones had a small gap that can allow dirt and debris to get in. had to adjust several times to cover completely. Material is high quality. Will work Just not a tight seal to keep grease in and dirt out.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
A Customer
Date: September 23, 2020
I finally got around to installing these. They work OK but they're a little bit small for 1 ton tie rod ends. I'll run them for now but I will replace them when I get the proper size.They are much thicker than the stock boots. That was nice.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
layne brannon
Date: September 10, 2020
Ripped grease boot off of the drag link end on 2003 jeep wrangler didnt want to replace whole steering system yet so I tried these bushing and they fit perfect!
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
brian buford
Date: August 12, 2020
Energy Suspension is a name you can trust, and these boots are no exception. You know the story: building a truck, previous owner bought new tie rod ends and lost the rubber boots, grease zert , cotter pin and castle nut, anyway these boots are great!
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
James R. Nelson
Date: August 04, 2020
Good product
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
IOwnCalculus
Date: July 27, 2020
I installed a Moog DS1430 tie rod / drag link on my 2002 Jeep Wrangler as part of an overall steering refresh/upgrade. Within 500 street-only miles the boot on the link completely split.This is a perfect replacement. It does go on very tight but it finally seats with a pop once you start getting the joint torqued down.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
V. DESHAZER
Date: July 13, 2020
just the right amount of stretch and fit perfectly - much better than the original rubber boot
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
brandon
Date: July 09, 2020
Perfect fit for 2006 wrangler tie rod!
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]