I bought these burrs expecting them to last a couple uses at most because.... I mean come on, look at the price! Since I got this burr set back in 2020 I’ve used the on wood, aluminum, brass, copper, mild steel, spring steel, 1095 high carbon knife steel, and to my amazement all but two still work. I bent one the first week because of using too much force and another got vacuumed up, never to be seen again.I see people complaining about bending them a lot. This is due to a few factors.- bit extended too far from rotary tool.- pressing too hard on tool. (Let the tool do the work, don’t muscle it)- bit made contact with tough material on opposite sides, binding it.- rotary tool is junk and vibrates due to Imbalance.A few things to note, never use these bits without adequate eye protection. I had some cheap glasses and caught a piece of metal that somehow got under the glasses due to my negligence. Also, the chips these burrs send flying are very sharp and very hot. So be careful.
Rating:
[5 of 5 Stars!]