skip to footer block
PDL Firestone W56RAC1650 LF FormFlash 9" x Linear Foot P3962797PDL-W56RAC1650-LF https://cdnimages.opentip.com/full/PDL/PDL-W56RAC1650-LF.jpg Firestone W56RAC1650 LF FormFlash 9" x Linear Foot Manufacture part number: W56RAC1650-LFFirestone QuickSeam FormFlash is an uncured EPDM flashing laminated to cured seam tape. QuickSeam FormFlash is used to flash inside and outside corners, pipes, penetration pockets and other applications.QuickSeam FormFlash Method of ApplicationUse QuickPrime Plus and a QuickScrubber or QuickScrubber Plus pad and handle to clean and prime mating surfaces.When cloudy conditions below 60 degrees F occur, use heat guns (without ignition sources) to heat QuickSeam FormFlash. This will ensure good formability of the QuickSeam FormFlash to the primed substrate.On sunny days less than 70 degrees F lay out QuickSeam FormFlash (prior to application) with flashing side up to allow QuickSeam FormFlash to warm to ensure good formabilityOn sunny days greater than 70 degrees F, lay out QuickSeam FormFlash (prior to application) with release paper up to prevent QuickSeam FormFlash from gaining too much heat and ensure food formability. 3962797 0.5000lbs 0.00 0.00 0.00
Firestone
9.9900 2025-07-21 In Stock

Firestone W56RAC1650-LF FormFlash - 9" x Linear Foot

Brand Firestone
Shop more from PDL

SKU: PDL-W56RAC1650-LF
Price: $9.99
Quantity:
Shipping:
$15.99 To [ 43215 ]
In Stock
Share & Earn 10% Cash Back Best Price in Bulk

Product Description

Manufacture part number: W56RAC1650-LF

Firestone QuickSeam FormFlash is an uncured EPDM flashing laminated to cured seam tape. QuickSeam FormFlash is used to flash inside and outside corners, pipes, penetration pockets and other applications.

QuickSeam FormFlash Method of Application
  • Use QuickPrime Plus and a QuickScrubber or QuickScrubber Plus pad and handle to clean and prime mating surfaces.
  • When cloudy conditions below 60 degrees F occur, use heat guns (without ignition sources) to heat QuickSeam FormFlash. This will ensure good formability of the QuickSeam FormFlash to the primed substrate.
  • On sunny days less than 70 degrees F lay out QuickSeam FormFlash (prior to application) with flashing side up to allow QuickSeam FormFlash to warm to ensure good formability
  • On sunny days greater than 70 degrees F, lay out QuickSeam FormFlash (prior to application) with release paper up to prevent QuickSeam FormFlash from gaining too much heat and ensure food formability.

warning tips WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.p65warnings.ca.gov.
Need more information?
Our staff are available to answer any questions you may have about this item


Customer Reviews
0 reviews
Be the first to review this item!