While the tang arrangement on the back of this new switch was/is different than the one it's replacing, it all worked out perfectly and the new switch is working flawlessly. I'd order from here again in a heartbeat.

Replaced a non lighted switch. Wire so when light is on there is power to the exterior light.

If the switch works but is illuminated all the time, just reverse the load/power leads. It will then just illuminate when on

Replaced the one in my RV that was flickering on not lighting at all. Good to go.

Not used, bought as a spare. But is same as factory and based on that one it gets 5 stars for lasting for years.

Exactly what I needed for our RV heater

Perfect match for Winnebago 135740-06-01A. Lighted red switch used in my model for electric power to water heater.

Snapped out the old switch and snapped in the new switch took a minute to figure the wiring to the light would work. All is good.

Bought this switch like some other consumers to use in an RV. I would occasionally leave an exterior light on overnight. Switch was an exact size replacement for my original, non-illuminated switch so it fits in my mounting bracket perfectly. Worked like a charm 1st time.

These work great, but be aware that they have three lugs, not two like shown.Your old unlighted switch will have two. The power loops through the switch. But the third lug is for a ground to make the switch light up. This may or not be easy. On my RV I don't have access to the inside of the wall. Other switches nearby with dimmers have a ground and so the plan is to use a 'PosiTap' and share that ground.Like everyone else, I can accidentally leave on outside lights or the water heater run because the switch is easy to overlook. Hopefully, these will solve that.

Love this switch! I accidentally left my outside LED awning lights on while camping this past summer. It drained my battery quite a bit running them all night long. The switches are visible from the bed in the trailer, and now with this illuminated switch I can see when they are on without sticking my head outside the door. There was already a ground (white wire) close by that I tapped into to power this light. It functions and looks just like the solid switch in the same panel. Removing the old light was difficult as they snap in very tightly. You do need to have the housing for this switch to snap into first, it does not come with one in the package. If you have these style switches installed already, this is a fantastic upgrade.

One month to return is too soon. Dont buy from here if you are not sure of your switch. Picture shows two leads on one side but there is three in parallel. Bad product pictures.