Not sure if I'm not using the tool correctly or if my locks are just really bad. However, it is a pretty strong tool.

Nissan is notorious for have sagging doors.After dealing with slamming the car doors for years, I decided to check this out.I originally was looking at the Steck Manufacturing tool, but the primary vendor looked really suspect when you checked them out; there are cheap China copies that are around half the price that the original Steck tool is asking for.Yes, this Lisle tool is bulky (something the Steck tool likes to point out), but it's one-piece and can handle the abuse of being used over and over again.You don't need to crank on it - just a little at a time until the door closes nicely.The double ended stud came in handle, as my too came with the thicker stud installed.A 16mm semi-deep socket and it came right out - flipped it over (to the thinner stud) and I was ready to go.The stud is the part that goes into the door latch while the fork goes onto the door jamb catch.Literally a minute or two on each door (I needed to do 2 doors), and they were shutting without much fuss.It took me more time to figure out how to undo the door latch catch afterwards versus adjusting the door itself!

great product for a good price. been looking for 1 for months. worked as intended and am very happy about the buy.

Excellent

All positive.

Extremely reliable, heavy duty built.

Good

Great price, high quality. Cuts your adjustment time by a lot, highly recommend for body techs

I replaced a creaky lower door hinge on my Grand Cherokee. I could not get the door aligned properly after that. I must have spent two hours, and I could get it close, but not quite right.Was thinking about taking it to the body shop, but then stumbled across the Lisle door adjuster. Decided to take a chance, since it was still a lot cheaper then a shop visit would have been.I loosened the lower bolts a little bit, not too much, but enough the hinge could be manipulated but still stay where you left it.Put the tool in place, lifted up on it a few times since my door was hitting too low. Carefully opened the door and tightened the bolts. And just like that, it was PERFECT!Literally 3 minutes and done. A M A Z I N G ! ! !

Works well.

Easy to use

I was watching Robby Layton on Youtube and he used a similar tool to line up a door. I had a door on my Nissan Versa I had replaced and could never get proper alignment. With this tool I was able to line it up in 5 minutes. Highly recommend!

Works as it should, easy to use. Feels nice and sturdy in your hands/

Easy, simple, well made

Wish it wasn't so big but I love the dang thing.

Good product easy effective usage, true value.

Should of bought one a long time ago.Replaced the hinges on a '78 2 door Aspen, and could not get the door lined up correctly.This saved alot time and headaches.Made in USA

Works great as advertised

Good value tool

Great tool. Bought it because my door started hanging but bolts were tight. Worked perfect.