Replaced broken one, fit perfectly

Perfect fit to replace damaged valve assembly on our Flame King - YSNHT500 gas grill.This grill comes with many RVs and has different names so it is hard to find parts for. This valve fit and works great

I looked al over for this part now I can hook up to my BBQ to the low pressure rv line along with my Blackstone .

This replacement LP gas valve and knob looked like a good combination and cost-effective way to replace a valve that had frozen on my gas grill. No problems with the valve or the knob, but I had to return this because the diameter of the inlet line wouldn't match the fitting on my regulator hose. Otherwise, a good purchase.

This valve allowed me to convert a UniFlame portable grill to run off the propane system installed in my popup camper.FYI, If you don't get any flow to the burner, double check that your quick connect fittings are all the same type. There are two different styles, called Model 250 and Type 5LPN. The model 250 male plug will fit into the Type 5LPN female socket, but not engage the internal valve and allow the gas to flow. My camper had the Type 5LPN for the cooktop, and I needed to make an adapter plug because the valve has the Model 250.

Perfect replacement after I dropped the grille and broke the original

This product met expectations.

This works well for our portable gas grill as we use it with our rv propane tank. We were so glad to find it.

Used to remove regulator from table top BBQ for use on RV with built in propane outlet

The part itself is what I needed to able to use my Anywhere Grill by Weber. Don't think your just gonna buy this and pop this thing on. I spent about a total of 2-3 hours researching the correct fittings to attach this valve. Long story short I removed the factory regulator and reused the original orifice and retaining clip. There 2 fitting you will need. First one is 1/8 NPT Male to M12x1.5 Female Fitting which the blue one you see on the pics and the second is 1/8 NPT Female to 1/8 NPT Female coupler which is the brass fitting. Blue fitting to this valve, then the coupler to join the valve to the orifice. Now you just connect your quick connect hose to grill and then the RV port. Now this kinda puts the valve a little further out but it's close enough to clear the swinging leg to stand and close the grill. Hope this helps the next guy!

I can't believe you can buy this much quality so inexpensively. Works on my SS grill just perfectly.

The regulated valve on my Cabela's grill was no longer functioning well plus I wanted to hook my grill directly to the gas supply on my 5th wheel. Since the gas is already regulated at the tank I needed a non-regulated valve. This one fit the bill. I did file off the flange a bit so it sits without interference on the grill. It works better than the original valve ever did.