Worked as expected and described

Bought these because my local pool store was out. A lot less money and they work just as well. Great buy for the money. Could actually replace 4 of these for the price of 1 at my pool store.

These surely fixed my problem. I've had them installed for 2 months with no issues. My 18 inch raised spa now stays full when the pumps are off. If they start leaking within the first 2 years I will update this post.

Fit perfect

Exactly as described, perfect fit to replace worn out Jandy flappers. Much better than having to buy the entire unit, which Jandy makes you do.

These flappers are a great replacement. They fit my Hayward check valves. Hard to find just the flapper. Easy and cheap fix instead of replacing the whole valve.

Easy to install

Easy to install. Turn off pump and remove screws, keep the screws. Make sure you put it back in the same position reattach screw. Works well

the check valve for the spa portion of the pool wore out, as they do. The replacement valve by ATIE was easy to install and works perfectly.

I have a nearly 20 year old pool system and have had to do some repairs recently. I have never opened my check valves but I have been having the water drain back into the pool for some time but never thought about the check valves being the issue. Once I determined it was the culprit, I started looking for replacements and came across these. Reviews were mostly good but some had issues. Not me.I can tell you that I installed 3 of these in about 15-20 minutes, used Pool grade O-ring lube on the new valve flapper and o-ring seals, and tightened by hand in a star-crossed pattern (like lug nuts on a car tire), and I have had no issues whatsoever. I did inspect the inside of the check valve housings and found some contaminants that needed to be scraped away prior to installing the new flapper. The contaminants were built up and could have prevented a tight seal. I also put some o-ring lubricant inside the valve where the flapper will be seated to ensure a nice seal.Anyone can do this change, I just recommend you wear some latex gloves, bring some paper towels to wipe off excess o-ring lube, and only hand tighten the screws when reinstalling. Old plastic can be brittle and over tightening can easily crack the housing where the screws are inserted.

Simple thing to change if you find your spa has lost water overnight.

Identical fit form function as more expensive brands, best value.

Poped off the old one installed new perfect fit, easy peasy

This part works perfect! Was simple to install and now my hot tub doesn't backflow in to the pool when the pump is off. Also, my water features are working better too!

Perfect fit. Good value.

This part kept my spa water from draining into the pool

I ordered this to repair a leaking Jandy check valve. It was part of the valve assembly that kept the water level constant in the pool spa once the pump shut off. It was a perfect fit and stopped the leak immediately.

Typically check valves like this seem to last me about 2 years or so before they fail. Time will tell if this particular brand is any better or worse, but for now they're working perfectly. I have an elevated spa/hot tub that spills into the pool, and when the check valves need replacement, it's obvious because my hot tub is empty in the morning.They look and fit like OEM Zodiak or Jandy check valves. I replaced both valves in this two-pack under my wife's watchful eye in under 10 minutes. They come with the necessary O-rings, and because I have two to replace each time, I really like that they come in this two-pack.If these last for at least 2 years, I'll be back for more when they fail.Hope this helps.

Easy to install just remove the 8 screws from the old one. Remove the old one. Install o-ring on the new one and lube. Remove the retaining wire but hold the flapper down. Align the part with the valve body. Release the flapper as you slide it in place and hold it down. Reinstall screw.

Perfect fitremember to clean the seat of the valve as well