4.5 out of 5
Customer Reviews
Items 1 - 2 of 2 reviews
1
By
William M. Murray "murray500"
Date: December 12, 2010
I'm using this to cut out spot welds - old car body restoration.The tool is basically an end mill with a center locating pin.Recommend drilling a thru hole with a small drill bit first, then using this tool.Makes nice clean holes. Have cut about 30 welds and still sharp.
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By
William M. Murray "murray500"
Date: July 30, 2007
The tool arrived quickly, and has a spring-loaded pilot, which kept the cutter from walking off the spot weld, once you center-punched it. The cutter worked well and fast, but on the first day the pilot broke off. The vendor later replaced the tool without any hastle, WISH I TALKED TO THEM ABOUT IT SOONER!
Rating: 
[4 of 5 Stars!]
[4 of 5 Stars!]
Items 1 - 2 of 2 reviews
1