Good

I use this on my Cummins truck and really like it,the only problem was the male plug broke after a short period of time so I had to buy another one

could be a bit less bulky but over all very nice and good quality, worked perfect for making a external plug in for a maintainer

Very good quality from this company. Not everyone has a 2 hole saw or a drill to drive it, but if you do this works great once installed.

I needed one entree the female end was outside so I could have an outside plug. I'm sure this one is fine, just the wrong product for my use. My bad. Not the seller.

Look awesome

great product, replaced my broken plug and now is good as new.

High quality and easy to install.

Worked perfectly for what I needed.

This plug extension isperfect...

Installed easily, painters tape and running hole saw in reverse on fiberglass is the trick. Gasket deformed a bit as it tightened down, but hopefully that means a good seal. I used a small amount of silicone as well for insurance.

I needed a male power plug for a busy workbench/chest of drawers, and the tight angled offset in this plug's wiring was just the ticket. I bought the less expensive 'Dumble Power Inlet Port' first and tried to modify it to fit. Bad move. After cutting it up I couldn't send it back, and the cutting merely made a messt. The NOCO plug cost almost twice as much, but the angled wire clears the drawers and the cabinet perfectly, so the cost of the Dumble plug goes in the tuition column. (NOCO makes a number of fine products BTW. I have had 100 success with them.)

I installed this in my 2022 Sierra Denali 3500 to use as a transition the my onboard battery tender. See the batteries in the truck go dead after 5 days so I had to install aa two battery tender. It works perfectly.

Fits my dog very well. I bought this harness to replace the same unit but a smaller size when my puppy was smaller. Easy to put on and take off.

Installed this along with the NOCO Genius 2D battery charger / maintainer on my 2004 Jeep Wrangler TJ Rubicon. Installed the port on the passenger side front fender well and the Genius 2D right below the air box on the passenger side inside fender. The only issue I had was I had drilled the 2 hole and did not account for how deep the port sits in the hole. My solution for this was getting a hockey puck and cutting it in half and using it as a sort of spacer between the port and the fender well. It worked perfect and is the exact same diameter as the port itself so unless you look closely you can not even tell I used it. This was to prevent the back of the port from hitting the A/C lines right behind where I drilled the hole. The port does include some self tapping screws but I opted to replace those with bolts and nylon locking nuts just to be a little safer and make sure it never comes loose. Another thing I did was purchase 1 heat shrink tubing and putting that over the plugs from the Genius 2D and the port itself just to insure it does not come loose or get water, dirt, etc. inside the connectors there. I absolutely love this and it makes for a faster, easier, and more convenient way of plugging my Genius 2D in, instead of having to open the hood and find the cord that way or dangle it down below the engine. The product feels super high quality as well. Very happy with my purchase.

Very well-built, great value for your money

Used for a month plugged into twice thats the ground is super loose

I would like to say that this came packaged perfectly and securely i am verypleasedand happy with it

Very high quality and same day delivery, you can't beat that.

I took a star off because while it has 3 holes, it only came with 2 self tapping mounting screws, which... I mean, come on, there's not a lot to QC before this thing goes out the door, can't you at least make sure it's got the right number of screws?