I was working on my son's motorcycle and after a few months of it being in the shop, we finally finished all the repairs.Since the bike had not been run in a few months, the fuel must have gone bad or was close to it. We started it up and after priming carbs and fuel line it was really hard to start. Once we were able to get it running the midrange jet must have been partially gummed. It was stumbling in the midrange under throttle and I just KNEW I would have to remove all 4 carbs and get to work on another project.I did a little research and found an article mentioning PRI-G. I thought to myself that I have been known to buy snake oil in the past, I could certainly try this one in this situation.I mixed up 2 gallons of fresh fuel, added the PRI, and crossed my fingers hoping for the best but keeping expectations low.I KID YOU NOT! about 5 minutes into idling and blipping the throttle a little to allow some of the new fuel to run through the lines, this bike is purring like a kitten. Smooth throttle response all the way through the range.If I hadn't experienced it myself, I would just smile and nod. But! NO JOKE this stuff really worked. HOW? The amount I put in the fuel was almost measured in drops as you put in 1 oz per 16 gallons.Whatever the magic is, thank you!If anything happens to undo this review, I will post an update. But this was my experience.
Rating: [5 of 5 Stars!]