Will not thread onto new bolt!!! Don't waste your money!!

The outside Dimension is too large for the die handle. It was me to an improper spec. Bottom line it's greater than 1 inch. I guess quality control doesn't count anymore.

well belt

It did the job

Saved me a lot of extra work on not replacing the wheel studs/bolts.

I ordered the 27x1.5 die to re-thread the damaged end of a CV axle in a customer's BMW X5. I had to borrow a 50mm socket to drive it with, but when done, I have usable threads and can re-install the axle.

Threading die didn't fit any of my T- handles. But die is heavy duty and works well with an adjustable wrench.

Repaired and cleaned very-badly rusted/pitted/dented threads on an abused bench grinder in less than 5 minutes. Impressed.

correct sizing, good quality. only used once, but it saved my butt, didnt have to replace an axle.

Pictures show before and after.I've been living with a bit of thread damage that I didn't get ahead of on my spindle thread and one fateful evening fueled by a bit too much coffee I tightened my ER25 collet nut a wee bit too tight on a warm spindle. When I came back to do a toolchange, the collet nut had cooled but the spindle threads retained enough heat that an enthusiastic attempt to loosen the nut around the slightly heat-expanded spindle threads deformed the collet nut and then dragged the deformation across all of the threads, severely damaging an irreplaceable component of the spindle.Faced with a 4-6 week lead time for a new $400 spindle from China or a 1-2 week lead on a $1000 domestic replacement, I decided to attempt to rethread the spindle with this $40 die that arrived within two days.2 excruciatingly stressful hours of mashing through my threads and a can of WD-40 later, my spindle is in fighting shape again with no concerning vibrations. I chucked in a 1/4 tool blank and there is no wobble whatsoever. The crests are still damaged but the roots are very crisp and clean.

Needed to extend the threads on some grade 8 (well really class 10.9) bolts. Die was the M12x1.25. Got all 10 bolts cut but did get harder towards the end. Probably won't ever need it again. It did save me about 60 bucks.

I used this to clean up buggered up trailer spindle threads that someone had smashed up in the past. Worked great; a lot easier than replacing the spindle and much cheaper than a new axle.I haven't used it a bunch, just a few times cleaning up threads, but it seems decent quality. Fits a 46mm or 1-13/16 socket.

Purchased to straighten wheel stud threads on a metric 14 bolt axle

I didn't break it so it must be pretty good

Cheap steel hogged out with dull cutting tools.

saved me money not having to buy a new axle

Very good product far price

This is the sheerest and thickest die I have ever purchased 5 stars in my book???

Purchased the 5/8-24 good quality. To thread the barrel on my .308 works perfect the nut size is 1 1/4 would buy again for sure if i needed one of a different size

Most of my die set you can tell what side to start with. This one I could not tell. But worked perfectly. A bit pricey but no one else had this odd size