This is such a good item, it truly makes life a bit more organized and is durable too!

Just what I needed and worked great

Works as intended

I guess they felt they wanted to challenge me and not include the hinge template. That made things a lot harder as far as installation. Otherwise a great product.

This is a high quality product and was relatively easy to figure out how to install it, thanks to my son who helped us. We actually were better off without the instructions as they actually confused us at first. I love the soft close mechanism and the long length of it for my laundry room sink. It is a fantastic product.

Easy to install and looks great. Fit perfectly. Followed the directions exactly, and the sink face door closes tightly with no gaps. I really like the soft-close hinges. Note: mine came with two different instruction sheets. One sheet mentioned using an included template to mark hinge holes for drilling, one sheet used only measurements. I called Rev-a-shelf to ask for a template. They said soft-close hinges do not have a template, and to use the instruction sheet with only measurements. No biggie, it still installed easily. Before I removed the sink door, I put painter's tape on the cabinet face frame around the outside edge of the door, to make sure the door was in the exact same place after installation...and it was, with no adjustments needed. This also helped with figuring the reveal measurement on the instruction sheet. Without the door tilted out, it looks exactly like it did before installation...which is what I wanted. Our previous cabinets had a tilt-out tray, but it was white plastic. The stainless steel tray is a nice upgrade.

Operation is good, but the installation instruction could be better. Mine came with multiple instructions on different sheets and I was difficult to tell which was correct. One set was folded inside the hardware bag, the other was wrapped around the tray itself.My best advice is to test fit everything, if I had followed the directions as written (either set) the drawer would not have closed properly as the hinge needed to be installed off vertical to have sufficient tension to close the trim tight to the cabinet.Once installed it works well.

This fit perfectly in the fake front in front of my sink! I watched a few YouTube videos on how to install these so I didn't need the directions. I think just using the directions I would have been confused. Look me 15 minutes to install and I wish I would have done this sooner!!

Installation takes about 15-20 min. The stainless steel tray is a big improvement from the plastic trays. The soft close hinges is a nice feature.

Quality product that's definitely a "must have". On the other hand, the installation instructions (and diagrams) leave a lot to be desired. I wasted a lot of time trying to figure out the instructions, but once I tossed them and used old fashion common sense, it went pretty smooth.Before removing the cabinet face, use a pencil and trace the opening on the back of it.Install the two hinges, flush with the bottom and front of the cabinet frame.Measure from the side of the cabinet frame to the center of the openings where the screws will attach it to the cabinet face. They are oval, so you have a margin of error to work with.Add that measurement to the vertical line you originally traced on the back of the cabinet face and draw another vertical line.From the bottom traced line, fo up 1/4" and put a mark on the new vertical line you drew. That will be your first drill hole to attach the bracket to the face.Measure up from the bottom edge of the cabinet frame to the upper hole of the bracket and then apply that measurement to the new vertical line as well. (I can't remember what that second measurement was). Drill your holes.Repeat for the other side.At this point I decided it would be easier to remove the brackets from the cabinet frame and then attach them to the cabinet face. Don't over tighten. Leave a little play so that you can move the brackets side-to-side with a little pressure.Then, I placed a towel over the lower cabinet doors so that I could use them for support while getting the cabinet face lined up. From there, I used a phillips screwdriver to attach the left bracket to the left side of the cabinet frame and then did the same for the right side. Everything lined up perfectly and I used a stubby Phillips screwdriver to tighten down the screws that I had intentionally left a little loose.Don't forget to drill your holes to attach the tray. You can do that at any point before the final step of the install.

returned for credit

The hinges are easy to install; flush to the front bottom edges. The drawer cover is hard; you have to layout the location of the holes (just do one on each side at first), and the tray has to be marked from underside. My drawer face only had a half inch edge from the hole and that allows the hinge to fully open and lock in place. Taller and some trimming would be required. My opening was 33 inches and that is as narrow as you can install that tray with the hinges. Although it took some time and care to install, it works great.

It looksgreat

This may have been easier to install if I had received the template. I had to go off of measurements and it wasn't that bad it looks good and serves it's purpose.

We bought a wide drawer with soft close hinges. Instructions were not great. We ended up having our handyman install and he had questions about the instructions too. It went in fine, just took a few extra minutes to figure out what goes where. Nice addition to the kitchen and keeps the little junky things out of the way.

Nicely made. Fit perfectly. Arrived earlier than expected! I am well pleased. No more junk visible on the sink! Soft close hinges are a must. Easily lifts out for cleaning.

I really like the extra WIDE stainless steel tray. So much better than the smaller plastic trays and the soft close hinges make this the best I've had. It's easy to clean and holds a lot.I recommend this item

Well made and works great.

My favorite new addition to the kitchen

Use it for a spice holder in front of my gas cooktop