5 out of 5
Customer Reviews
By
ken knutson
Date: January 08, 2023
Make sure you know where your eye bolts on your camper are first! You can't adjust the brackets once the camper is on the bed of the truck (I found out) Used the mounts plus chain securements on my 2010 F350 to pick up a truck camper a thousand miles away. Had never used them before and never had a truck camper before. Looked at videos on how to mount them. The camper I bought had jacks that didn't work so it was a pain to use car jacks to lift a little here then support it then lift again on another jack to be able to get at the mounts to move them in the correct spot. Once I did that it they held great on the way back home. No issues at all with them
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By
Merry Freelove
Date: November 20, 2022
The original running boards were almost rusted completely through only 4 years old. We don't think we'll have a problem with these because they are sturdier than the factory pair.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
jeff arrendale
Date: October 20, 2022
Well built
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
dave
Date: August 14, 2022
On my 2nd set of these (sold my original set with the last camper and bought another) and couldn't be happier. I actually have them mounted and have the rails of a soft roll up tonneau cover over them. Best of both worlds. They are easy to install and hold my older sun lite slide-in in place with no issues. Down washboard and mild “off roaring” the camper stays in place. Well worth the money
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
robert finegan
Date: July 25, 2022
Value
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
patience
Date: July 05, 2022
Put these on my 15 F250 for my oversized slide in camper. I was worried at first since i have a terrible long dirt driveway and i drove terrible roads for hours. they stayed tight and secure the whole time with a set of turnbuckles. Perfect for what i need especially compared to spending 10x as much on frame mounts to only use it a few times a year. unless youre doing so serious extreme offroading, these will be perfectly fine.Highly recommend a set of timbrens as well.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Chris Kelley
Date: December 22, 2021
I installed in my truck bed in about 30minutes. Put the camper on and was tied down solid in about 15 minutes. Camper is on solid.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Adam Ryan
Date: November 24, 2021
After 3 years of use on my 95 Lance Squire truck camper these brackets will hold up fairly well for street and highway use. However, if you need to get to where you are going on a bumpy dirt road they will bend and get stress cracks in them over time like mine have done. I've bent them back into original shape with a 20 ton press but I believe their time has come to be retired after doing this twice now. Going to have to spend some REAL money on truck frame mounts that mount to frame of my F-350. Coming down steep off road conditions finally did these in. But then my Lance truck camper manual specifically says not to take on extreme off road which I have many times while also pulling a 10,000 pound trailer full of lumber and gear. Again, these work well for light use on paved road ways but don't expect much traveling off in the outback!
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Helen Trepp
Date: September 16, 2021
Very good, we have heavy lance truck camper so very strong, no problems we crossed US with them, easy to put on
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Haggard Currier
Date: September 02, 2021
Easy to use easy to install great product keeps the camper in the truck
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Sherry Salazar
Date: August 28, 2021
Purchased this item for my camper on my Nissan frontier and it worked great
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
TNTSIERRA
Date: August 05, 2021
I could not make this work for my overhead pop-up camper so I had to use ratchet straps attached to my frame to make my vacation on time. I left these Brophy Tie Downs attached to my bed but when I took my camper off I noticed that one of the welded nuts that the T-bar threads through busted off. They were not even being used so imagine if I actually had my camper attached. Unfortunately I am not able to return now that it has been over 30 days since I bought them.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Glenn
Date: July 01, 2021
After installing the units which was very easy to do. I took the vehicle and camper on a 4000 mile trek and put it through its paces. All went well and the Brophy product worked fine.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Austin Gladden
Date: June 19, 2021
Got my Lance Squire 3000 from Oregon to California, 14 hour drive, no issues. 2006 F-250 Diesel. The truck I hauled it with won't be the one I use primarily with it so this was a great, inexpensive alternative that would likely work long term as well, I'd just feel better having it attached to the frame of the truck.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Sheryl Brown
Date: May 30, 2021
Love it. Works great.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Jason
Date: May 06, 2021
These worked great on our 2011 Chevy 2500hd. Secured the lance camper really nice
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Brian Wilkins
Date: May 06, 2021
Stick out too far to allow camper jacks to clear. Had to disassemble each one to clear camper jacks. Pour design.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Charles J Jelf
Date: February 14, 2021
Well made product but unfortunately the bed on my 07 F350 won't allow for mounting of the front mounts far enough forward to be ahead of the mounts on my truck camper. This resulted in my camper working it's way to the rear of the bed. Unfortunately, the 30 day return window expired a week ago so out of luck returning them.I have Torklift hitch mounts on the rear that came with the camper so my application was kind of unique. I ordered Torklift front frame mounts rather than go with all 4 Brophy's.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
paul
Date: December 05, 2020
Didn't like the packaging at all and the cardboard box was all busted up and had been retaped. The product was all there but the nuts bolts were not. The box is too light duty to carry steel parts that have sharp edges and corners. The product appears to be very strong and well made.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
William P. Rivers
Date: September 01, 2020
They are very heavy duty. The foam padding was kinda light weight. They held camper down dirt roads!
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]