5 out of 5
Customer Reviews
By
WYDave
Date: September 11, 2020
This went on and works GREAT for my Weller Professional 260/200 Watt D550 soldering gun.Took a bit to get the tip bent correctly to use, but the description NOR the pictures show that it comes with the nuts/screws, and OBVIOUSLY they can't pre-bend them as then you couldn't het thr nuts/screws on.If you want them pre-bent and with the nuts/screws on, you can find them, but you'll pay TWICE as much and only get 1.And for the price and getting 2 of them, there is NOTHING to complain about.This is for a review of the Weller part 7250W (see attached pictures)
Rating: 
[5 of 5 Stars!]
[5 of 5 Stars!]
By
Chickenpiss
Date: September 11, 2020
Purchased them knowing prongs needed some bending to fit in Radio Shack soldering gun, but works great!
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
A Customer
Date: September 10, 2020
Spread was too wide for my gun, but after bending it to fit it works great.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
dap pow
Date: August 18, 2020
you are better off using straight copper if you are soldering to the chassis. this tip does not last a long time if you dont let it cool down often. it has a low duty cycle time.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Kindle Customer
Date: August 04, 2020
Once i bent it a bit it fit on the Craftsman gun. Craftsman ones are pricey and it's hard to find a Sears still open where I live.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]
By
Marc
Date: August 03, 2020
Good tips. Fit and work well.
Rating: [5 of 5 Stars!]
[5 of 5 Stars!]