Ok, first I have to say I couldn't find the exact assembly I needed. Any vendor wanted almost $2000 for the specific assembly I needed. However, the mounting brackets aside, the fans, motor, and rubber grommets were exactly what I needed.Disassembling the parts from the incompatible housing, I was able to cut the old motor and fans off the housing part of my existing furnace and mount the new parts with ease. All in all the entire repair took about 30 minutes.Everything came as advertised and was able to complete the repair for a small fraction of what anyone else would charge. Super happy with this purchase.

Although the unit is described as being a direct replacement for an OEM Carrier inducer motor assembly... it isn't! Out of the box, the mounting flange on the unit didn't match the flange on the furnace. As a result, I needed to remove the motor and fan from the new unit and install them on the old flange(s) so I could attach it to the furnace. Once install everything worked fine.. however, in hindsight it would have cost about half-as-much if I would have purchased the pieces, (i.e., motor, fan and gaskets) individually.

Product was delivered faster than advertised and was easy to install.

Worked as should fit well found no issues but I feel cost was a bit much compared to other models ......

Nice

Review based on over a month of use at an average of 3x per week:Easy to install. Works great. Replaced Inducer Motor (P/N 318984-751) for an old Day Night furnace (395A Gas Fired Induced Draft Furnace Model 395BAW036060 Product 395BAW036060AABA ). Note: Do not throw screws from old part assembly. Will need to use on replacement.