5 out of 5
Customer Reviews
Items 1 - 9 of 9 reviews
1
By
robert kennedy
Date: December 10, 2017
The tool appears to be well built and higher quality than i would expect for the low price I paid. I gave it 4 stars only because I have not used it yet.
Rating: 
[4 of 5 Stars!]
[4 of 5 Stars!]
By
A Customer
Date: October 30, 2017
Worked well!
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
David Faigle
Date: June 01, 2017
Works well to spray undercoat..If it came with a container id give it a 5.. But still a good value..I used a gatorade bottle with a hole drilled in cap for a tight fit..This worked well but need a small hole for vent to keep bottle from collapsing from the suction..
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
Joe Alves
Date: December 05, 2016
work very well
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
Shank Wheat
Date: November 09, 2016
I used this to spray Fluid Film rust prevention on the underside of my car and it worked pretty well. It seems to be pretty well made and it cleaned up easily. My only issues with the gun was that there isn't any way to control the amount or spray pattern coming out of it. Also, I have a small 3 gallon compressor and I wasn't able to spray for more than a few seconds before having to wait again for the compressor to recycle again.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
PDK
Date: September 19, 2016
Used this to apply Fluid Film. Worked very well, no complaints at all. Hooked up a section of air hose I had laying around and sucked it right out of the gallon can.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
rich
Date: August 29, 2016
have not used it yet , but for the price it will be great
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
SPIKER
Date: August 27, 2016
I bought the spray tube but it took forever so I ended up heating some clear tube that slipped over the end and I melted it with torch and nail to poke holes into it at different angles that worked very well but was larger dia than the bought tube but 27bucks was a lot for that tube tool...
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
By
David M. Klinger
Date: March 08, 2016
Have not used the gun, but it will fit the undercoating container that I am using. I did need to cut the pickup tube, but now I know it is the right length.
Rating: [4 of 5 Stars!]
[4 of 5 Stars!]
Items 1 - 9 of 9 reviews
1