Exactly what I needed to replace worn out grip on my Onix Z5 paddle. New grip has some cushion and a little bit of tack. I took the old one off and wrapped this one on with the little perforations towards the bottom of handle. I had to adjust the amount of overlap a few times to get it just right. Too much overlap gave more grip ridges, but the length was a bit too short to extend to the top of the grip. Too little overlap made the grip very smooth. In between overlap (about 1/8”) has a little bit of ridges. You have to cut the end of the grip at a diagonal at the top to get a nice even end of the grip - do it only after you have the overlap just right. Then use several wraps of electrical tape to fasten the grip end to the paddle. Finally apply the Gamma tape over the electrical tape so it looks nice. 0-0-2!
Rating:
[5 of 5 Stars!]